
Sometimes your sketch end up open sketch and could not continue to add features from it. Open sketch can be connected to next line using Extend Entities tool. You can locate this tool from Sketch>Trim Entities>Extend Entities

Click the line you want to extend,

Line extended to next line,

To remove excess sketch line, click Sketch>Trim Entities>Trim Entities

Click on excess line,

Excess line trimmed and your sketch is now close sketch.


Advertise at this blog | About
divorce lawyers | DUI Lawyers
SolidWorks® is a registered trademark of Dassault Systèmes SolidWorks Corp.
www.solidworkstutorials.com website is not affiliated with SolidWorks® Corp.
© 2010 SolidworksTutorials.com. All Rights Reserved.
October 13th, 2009 at 3:48 am
Thanks, I usually drag the point to the edge. I been wondering the purpose of that tool before.